Simulating Radionuclide Transport Away from an Underground Nuclear Test: Linking Non-Isothermal Flow and Mechanistic Reactive Transport
The low-yield (0.75 kiloton) Cambric underground nuclear test situated in alluvium below the water table offers unique perspectives on radionuclide transport in groundwater. The Cambric...

Non-Destructive Strength Evaluation of a Continuous, Reinforced Concrete Slab Bridge
In the state of New Mexico, a significant number of reinforced concrete slab (RCS) bridges provide service on interstate highways I-10, I-25, and I-40 that are subjected to large amounts...

Application of TOPNET in the Distributed Model Intercomparison Project (DMIP)
This paper describes the application of a networked version of TOPMODEL, TOPNET, as part of the Distributed Model Intercomparison Project, DMIP. The model implementation is based on a...

Impact of Chemically-Induced Clay Transport and Deposition on the Hydraulic Conductivity of a Natural Sand
The purpose of this paper is to understand in part the dynamic impact of surfactants on hydraulic conductivity for designing enhanced pump and treat operations. This paper has two aims:...

Application of a SonTek Argonaut Side-Looking (SL) Doppler Flow Meter for Measuring Discharge on the Southern Leg of the Parana' River at the Entrance to the Itaipu Binacional Reservoir, Parana', Brasil
Index-velocity and water level data collected with a SonTek Argonaut Side-Looking (SL) Doppler Flow Meter and channel cross-sectional area data were used to compute total discharge on...

Calibration of Water-Velocity Meters
The U.S. Geological Survey (USGS), as part of its responsibility to appraise the quantity of water resources in the United States, maintains facilities for the calibration of water-velocity...

The Determination of Velocity Spectra and Dissipation by Direct and Indirect Means using Second-Order Accurate PIV
In this paper we present a 2 nd order accurate technique in space (following Wereley & Meinhart's (2001) extension of Cowen & Monismith's (1997) dynamic sub-window PIV...

Towers in Motion (available in Structural Engineering Special Section only)
Undersea towers are typically designed to rigidly resist the forces of water and wind. But one type of tower is designed to be flexible and, rather than rely on its platform strength to...

Design Live Loads for Parking Garages
The objective of this research project is to obtain a better understanding of parking garage live loads and to recommend an appropriate value for design. A load survey was conducted in...

Order Amid Uncertainty (Available in Geoenvironmental special issue only)
Bayesian statistical methods allow engineers to deduce probabilities from incomplete information. If there is a theoretical or empirical reason why a particular probability distribution...

Basin Response Time: Potential Hydrologic Basin Handprint
Hydrologic lead time is an important factor in many water resources engineering applications. The determination of the response time of a watershed to runoff-producing rainfall is the...

Comparison of Complete Modeling/Simplified Modeling of Zaragoza City Water Supply Network
(No paper) Zaragoza is a Spanish city with 600.000 inhabitants and a water supply network of 900km long. The Council technical services uses a Microstation based GIS, GRED, for network...

Securing the Stone
To prevent spalling at edges on thin stone veneer, engineers who design stone cladding pay special attention to the connection details. Kerf clips, 100-150 mm long, that distribute load...

Inspecting the Unknown (Available in Geo-Environmental Special Issue Only)
Unknown foundations have plagued civil engineers for years. In the case of underwater pilings, much time and money is spent inspecting for cracks, breaks or deterioration. Even then, visibility...

Evaluation of Sampling Properties of General Extreme Value (GEV) Distribution-L-Moments Vs Conventional Moments
The sample estimates of conventional moments are shown to be biased and this bias increases for small samples, and especially so when the skewness is high (Wallis et al., 1974). The recently...

FLODRO 2.0: A User Friendly Personal Computer Package for Flood and Drought Frequency Analyses
The use of personal computers have changed dramatically the way to perform several studies related with hydrological problems. The increased capabilities of the current generation of personal...

Dam Foundation Erosion Study: The Design of a Sidewall Orifice for Simulation of a Free Trajectory Overtopping Jet
This paper describes the design of a sidewall discharging orifice for simulation of a free trajectory overtopping jet. A sidewall orifice discharges through the sidewall of a pipe. The...

SpatioTemporal Stochastic Open-Dhannel Flow
The de Saint Venant equations are solved as stochastic partial differential equations whose parameters (hydraulic resistance, bed slope, cross-section geometiy, inflow hydrograph, seepage,...

Rational Design and Operation of Packed Bed Adsorption Reactors
Design of packed bed adsorption reactors is based presently upon the parameter empty bed contact time (EBCT), a fallacious concept. The column wave front behavior, instead, should be the...

Automatic Control of Flocculation Processes
A control system for flocculation, used in water and wastewater treatment operations is being developed. The approach is based on detailed particle size distribution measurements of influent...

 

 

 

 

Return to search